DIRT TRAX VIDEO INSTALLING OUR SYA WARRIOR RISER SNORKEL KIT

Made In the USA

We ship world wide.



EXTREMELY IMPORTANT!
HOW TO DETERMINE THE CORRECT SIZE WARRIOR WEAR PRE FILTERS FOR YOUR APPLICATION.WARRIOR WEAR PRE FILTER TIPS SNAP IN PLACE AND UNSNAP FOR EASY CLEANING. THEY ARE EASILY CLEANED WITH WATER AND RE USABLE. WARRIOR WEAR PRE FILTERS ARE LABELED AS EITHER 3" OR 2" OR 1 1/2" . THIS IS DETERMINED BY THE SIZE WARRIOR RISER THEY WILL INSTALL TO. HOW TO DETERMINE WHAT SIZE WARRIOR RISER YOU HAVE. THE BOTTOM ROUND PART OF THE WARRIOR RISER INSIDE DIAMETER IS WHERE YOU WILL MEASURE TO SEE WHAT SIZE WARRIOR RISER YOU HAVE. OR YOU CAN MEASURE THE OPEN TOP OCTAGON ACROSS AND COMPARE TO THESE MEASUREMENTS. THE 3" WARRIOR RISER TOP OCTAGON PART WILL MEASURE 4 1/8" ACROSS. THE 2" WARRIOR RISER TOP OCTAGON PART WILL MEASURE 2 7/8" ACROSS. THE 1 1/2" WARRIOR RISER OCTAGON PART WILL MEASURE 2 3/8" ACROSS. WARRIOR WEAR PRE FILTERS WILL SHIP IN BLACK COLOR ONLY. WE WILL NOT COLOR MATCH. ANY AND ALL COLOR MATCHING WILL BE DONE BY YOU THE END USER. ALL WARRIOR WEAR TIPS ARE SENT OUT UNGLUED. THIS ALLOWS YOU THE END USER TO CUSTOM PAINT THEM. THEN YOU MAY CHOOSE TO GLUE WITH OR WITHOUT THE WATER REPELLENT MATERIAL. INSTRUCTIONS HAVE ALL INFO ON THEM AND TYPE OF COMMONLY FOUND GLUE TO USE.

WARRIOR WEAR PRE FILTERS

SIZE AND QUANTITY
SIZE AND QUANTITY
SIZE AND QUANTITY
SIZE AND QUANTITY
SIZE AND QUANTITY
SIZE AND QUANTITY

TRADITIONAL SNORKEL GUARDS

SYA Snorkel Guards are pre filter tips that fit in the end of your snorkels. They are designed to work with our brand of Snorkel Kits , but will work with most Snorkel Kits and Homemade Snorkels. They are great at repelling Snow, Mud, Water, and dust. The size of the Snorkel Guards we offer are  1 1/2" - 2" - 3" .
They are measure by the inside diameter of the snorkel guard . For instance the 2" Snorkel Guard will have an inside Measurement of 2" and will fit in a 2" fitting . The Snorkel Guard tip will press into the Snorkel ends without glue. The further you press them in, the tighter they get. The reason you don't glue them in, is so you can take them out for cleaning. Clean them with clean water. These are intended for EFI machines only, not Carb machines. They are intended for operating on the intakes only. They are also great for Storing your machine for the off season and also for washing your machine.